汽车工程

汽车工程 ›› 2019, Vol. 41 ›› Issue (2): 126-132.doi: 10.19562/j.chinasae.qcgc.2019.02.002

• • 上一篇    下一篇

MF-汽油掺混燃料直喷喷雾试验研究

高东志, 郭勇, 王凤滨, 付铁强   

  1. 中国汽车技术研究中心有限公司,天津 300300
  • 收稿日期:2017-11-16 出版日期:2019-02-25 发布日期:2019-02-25
  • 通讯作者: 高东志,工程师,博士,E-mail:gaodongzhi@catarc.ac.cn

An Experimental Study on MF-gasoline Blends Direct Injection Spray Characteristics

Gao Dongzhi, Guo Yong, Wang Fengbin, Fu Tieqiang   

  1. China Automotive Technology and Research Center Co., Ltd., Tianjin 300300
  • Received:2017-11-16 Online:2019-02-25 Published:2019-02-25

PDF (PC)

395

赞

摘要： 电控直喷系统由于其具有良好的燃油经济性、热效率、排放和冷起动性能,广泛应用于SI发动机。目前2-甲基呋喃(MF)被证明是一种优于乙醇的生物质替代燃料,且其与汽油掺混燃料的直喷喷雾特性研究的较少。本文中应用6孔喷油器采用高速纹影技术研究M20,M40和汽油在不同环境背压和燃油温度下的喷雾特性。喷雾参数包括喷雾贯穿距、喷雾锥角和喷雾面积。结果表明,存在闪急沸腾和非闪急沸腾两种喷雾形态。当闪沸发生时,随着MF掺比的增加,喷雾贯穿距增加。随着环境背压的降低,贯穿距先减小后增加。喷雾锥角较未闪沸时增加,喷雾面积随着MF掺比的增加而增加并且与燃油温度呈负相关。当没有发生闪沸时,随着MF掺比的增加,喷雾贯穿距减小。

关键词: 2-甲基呋喃汽油掺混燃料, 多孔直喷喷油器, 高速纹影成像, 闪急沸腾

Abstract: Direct injection (DI) system has been commonly used in spark ignition engines for its good performance in fuel economy, combustion efficiency, emissions and cold-start. Currently,2-methylfuran (MF) has already been a more attractive biomass fuel because of its better performance than ethanol. However, there is little study on the DI spray characteristics of 2-MF-gasoline blends. In this paper, the spray characteristics of 2-methylfuran-gasoline blends M20 (20% volume fraction MF-gasoline blend fuel), M40 and pure gasoline from 6-hole DI injector are investigated under various ambient pressure and fuel temperature using high-speed schlieren photography. The spray parameters include spray penetration, spray cone angle and spray area. The results show that there are two different spray forms, flash boiling and non-flash boiling. When flash boiling occurs, the spray penetration increases with the increase of MF ratio. With the reduction of ambient pressure, the spray penetration decreases firstly and then increases. And the spray cone angle is greater than that without flash boiling. The spray area increases with the increase of MF ratio and the spray area is negatively correlated with the fuel temperature. When there is no flash boiling, with the increase of MF ratio, the spray penetration decreases

Key words: 2-methylfuran-gasoline blends, multi-hole DI injector, high-speed schlieren photography, flash boiling