灰分沉积对不同结构CDPF再生特性的影响*

doi:10.19562/j.chinasae.qcgc.2020.06.003

摘要/Abstract

摘要： 对某高压共轨柴油机的催化型颗粒物捕集器(CDPF)进行台架试验,研究了两种不同结构的CDPF对发动机性能的影响和不同碳载量下CDPF的压降特性。通过建立三维CDPF热力学模型,分析了灰分量和灰分分布系数对不同结构CDPF再生特性的影响。结果表明:CDPF会使柴油机动力性、经济性略有下降,但非对称结构CDPF可有效降低载体对柴油机性能的影响;CDPF压降会随载体孔道内碳烟累积量的增大而升高,非对称结构CDPF可有效减小CDPF压降,且随着碳载量增加,非对称结构的优势更加明显。灰分沉积有利于降低载体向环境传热的导热率,提高载体热容量,有利于碳烟的氧化再生;CDPF再生过程中载体的温度呈边缘低中心高、前端低后端高的分布规律。灰分分布系数对碳烟氧化速率影响较小,载体结构、灰分量和灰分分布系数对CDPF最大再生温度梯度影响也不大。

关键词: 柴油机, 催化型颗粒物捕集器, 再生特性, 灰分量, 灰分分布系数

Abstract: A bench test is conducted on the catalytic diesel particulate filter (CDPF) of a high-pressure common rail diesel engine to study the effects of different structures of CDPF on the performance of engine and the pressure drop characteristics of CDPF under different soot loadings. A 3D thermodynamic model of CDPF is established, and the influences of ash loadings and ash distribution coefficients on the regeneration characteristics of CDPF with different structures are analyzed. The results show that CDPF would lower the performance and economy of diesel engine, but the CDPF with asymmetric cell technology (ACT), i.e. asymmetric CDPF, can effectively weaken the effects of the filter on the performance of diesel engine. The pressure drop of CDPF will rise with the accumulation of soot loading in filter channels and the CDPF with ACT can effectively reduce the pressure drop of filter, and the advantage of the asymmetric CDPF becomes more obvious as the amount of soot loading increases. Ash deposition is beneficial to the reduction of the thermal conductivity of the filter to the environment and increase the heat capacity of the filter, conducive to soot oxidation regeneration. The temperature of the filter during CDPF regeneration is higher in the center and rear end and lower in the periphery and front end. The ash distribution coefficient has little effect on soot oxidation rate. The filter structure, ash loading and ash distribution coefficient also have less effects on the maximum regeneration temperature gradient of CDPF

Key words: diesel engine, catalyzed diesel particulate filter, regeneration characteristics, ash loading, ash distribution coefficient

陈贵升, 李青, 陈春林, 卢申科, 吕誉, 沈颖刚, 黄震. 灰分沉积对不同结构CDPF再生特性的影响^*[J]. 汽车工程, 2020, 42(6): 725-733.

Chen Guisheng, Li Qing, Chen Chunlin, Lu Shenke, Lü Yu, Shen Yinggang, Huang Zhen. Effects of Ash Deposition on Regeneration Characteristicsof CDPF with Different Structures[J]. Automotive Engineering, 2020, 42(6): 725-733.

参考文献

[1] ZHANG Y H, LOU D M, TAN P Q, et al. Particulate emissions from urban bus fueled with biodiesel blend and their reducing characteristics using particulate after-treatment system[J]. Energy,2018,155:77-86.
[2] 王建,曹政,张多军,等.基于DPF主动再生温度需求的柴油机进气节流控制策略[J].农业工程学报,2018,34(2):32-39.
[3] TANDON P, HEIBEL A, WHITMORE J, et al. Measurement and prediction of filtration efficiency evolution of soot loaded diesel particulate filters[J]. Chem. Eng. Sci.,2010,65:4751-4760.
[4] LI Y, WEINSTEIN M, ROTH S. NO oxidation on catalyzed soot filters[J]. Catalysis Today,2015,258:396-404.
[5] SAPPOK A, RODRIGUEZ R, WONG V. Characteristics and effects of lubricant additive chemistry on ash properties impacting diesel particulate filter service life[J]. SAE International Journal of Fuels and Lubricants,2010,3(2010-01-1213):705-722.
[6] BODEK K M, WONG V V. The effects of sulfated ash, phosphorus and sulfur on diesel aftertreatment systems-a review[J]. Journal of International fuels,2007,1:2017-2034.
[7] ALEXANDER S, WONG V W. Ash effects on diesel particulate filter pressure drop sensitivity to soot and implications for regeneration frequency and DPF control[J]. SAE International Journal of Fuels and Lubricants,2010,3(1):380-396.
[8] 张俊,帅石金,肖建华.灰分对柴油机颗粒捕集器性能影响研究综述[J].内燃机工程,2018,39(6):11-23.
[9] CHIARA F, WANG J, PATIL C B, et al. Development and experimental validation of a control-oriented diesel engine model for fuel consumption and brake torque predictions[J]. Mathematical and Computer Modelling of Dynamical Systems,2011,17(3):261-277.
[10] ZHANG J, WONG V W, SHUAI S, et al. Quantitative estimation of the impact of ash accumulation on diesel particulate filter related fuel penalty for a typical modern on-road heavy-duty diesel engine[J]. Applied Energy,2018,229:1010-1023.
[11] SAPPOK A, SANTIAGO M, VIANNA T, et al. Characteristics and effects of ash accumulation on diesel particulate filter performance: rapidly aged and field aged results[C]. SAE Paper 2009-01-1086.
[12] SAPPOK A, WONG V. Ash effects on diesel particulate filter pressure drop sensitivity to soot and implications for regeneration frequency and DPF control[J]. SAE International Journal of Fuels and Lubricants,2010,3(1):380-396.
[13] GAISER G, MUCHA P. Prediction of pressure drop in diesel particulate filters considering ash deposit and partial regenerations[C]. SAE Paper 2004-01-0158.
[14] ARAVELLI K, HEIBEL A. Improved lifetime pressure drop management for robust cordierite (RC) filters with asymmetric cell technology (ACT)[C]. SAE Paper 2007-01-0920.
[15] HEIBEL A, BHARGAVA R. Advanced diesel particulate filter design for lifetime pressure drop solution in light duty applications[C]. SAE Paper 2007-01-0042.
[16] JIANG J, GONG J, LIU W, et al. Analysis on filtration characteristic of wall-flow filter for ash deposition in cake[J]. Journal of Aerosol Science,2016,95:73-83.
[17] 张文斐.柴油机催化型DPF碳烟捕集再生的数值模拟与试验研究[D].天津:天津大学,2012.
[18] 李志军,姜瑞,史春涛,等.非对称孔道与对称孔道的 DPF 载体压降交点研究[J].中南大学学报(自然科学版),2018,49(3):732-740.

灰分沉积对不同结构CDPF再生特性的影响^*

Effects of Ash Deposition on Regeneration Characteristicsof CDPF with Different Structures

PDF (PC)

赞

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

Metrics

本文评价

推荐阅读 10

[1]	张翼霄,马骁,卢鑫辉,王志,诸葛伟林,帅石金. 柴油机喷雾碰壁引燃进气预热特性研究[J]. 汽车工程, 2023, 45(8): 1489-1498.
[2]	刘少华,董浩川,申立中. 基于碳烟粒径分布预测的柴油燃烧机理构建与氧含量影响研究[J]. 汽车工程, 2023, 45(1): 93-103.
[3]	沈颖刚,施伟杰,肖欢容,杨锐敏,陈贵升,毕克刚. CDPF主动再生对SCR性能影响的试验研究[J]. 汽车工程, 2022, 44(8): 1280-1288.
[4]	王俊,申立中,毕玉华,雷基林. 不同海拔下基于VNT驱动的EGR对轻型柴油机燃烧与排放的影响[J]. 汽车工程, 2022, 44(7): 1088-1097.
[5]	张慧龑,汤旭阳,石磊,邓康耀. 增压系统海拔自适应和调节能力研究[J]. 汽车工程, 2022, 44(2): 256-263.
[6]	肖仁鑫,梁大平,陈贵升,刘爽. 不同海拔下国六柴油机性能试验研究[J]. 汽车工程, 2022, 44(12): 1926-1935.
[7]	岳广照,孙振茂,田广东. SCR催化器温度在线预估算法及试验研究[J]. 汽车工程, 2021, 43(9): 1308-1313.
[8]	刘鹏,邓家福,范立云,吴钢,胡林. 串并联永磁对共轨高速电磁阀电磁力的影响[J]. 汽车工程, 2021, 43(8): 1136-1142.
[9]	靳莹,乔新勇,顾程,郭浩,宁初明. 基于Res⁃CNN和燃油压力波的柴油机喷油器故障诊断方法[J]. 汽车工程, 2021, 43(6): 943-951.
[10]	张韦,解礼兵,陈朝辉,周马益,陈永,范吉文,陶丽. 进气道螺旋段关键结构参数多目标优化设计[J]. 汽车工程, 2021, 43(3): 337-344.
[11]	毕玉华,聂学选,刘少华,肖奔,王鹏,申立中,彭益源. 排气温度、排气流量和海拔高度对SCR系统NO_x转化率和NH₃泄漏量的影响研究[J]. 汽车工程, 2021, 43(3): 350-357.
[12]	董意,刘建敏,李普,刘艳斌,乔新勇. 柴油机气缸垫状态参数预测与结构优化研究[J]. 汽车工程, 2021, 43(2): 232-240.
[13]	陈东东,王铁,李国兴,乔天佑,侯振宁. 瞬态工况下掺混PODE对混合动力柴油机排放特性的影响[J]. 汽车工程, 2021, 43(11): 1638-1644.
[14]	李青,陈贵升,罗赢,贺如,张涵,施伟杰. 碳化硅CDPF再生特性的关键性影响因素试验研究[J]. 汽车工程, 2021, 43(10): 1479-1487.
[15]	黄铁雄,胡广地,孟忠伟,曾东建. 面向控制的DPF再生效率建模和试验研究[J]. 汽车工程, 2021, 43(1): 44-49.